Question on 6095 jumpers

[BowieReefer84]

Ok, I just picked up two 6095's and a 7092 controller.

Should I use the 24v jumpers (the most powerful), and dial in the current via the controller? It came with so many different jumpers in the box...

Tank is 55"x22"x22" and I'm looking for med flow.

Thanks

 

[rvitko]

By lowering the voltage you keep the full range of flow adjustment within the voltage setting the maximum, I am sure your tank is large enough to make use of the full 24V at 100%, but if you need less I would try 22 or 20V and then you can still adjust between 30 and 100% and when pulsing the pumps, the farther apart your minimum and maximum the better the effect.

 

[BowieReefer84]

Thanks. I will give it a shot at 24V and go from there if I want to dial it back. This is my first time with Tunze pumps. I'm not looking for a wave as much as keeping deadspots to a min to avoid any buildup.