Question on DIY LED dimming and power

[badazztealcobra]

I thought I read that the Profilux will be able to actually turn off the LED drivers by using the 1-10v interface and I'm trying to see if this is true for all ballasts or only certain ones. I'm hoping I wont have to waste the spots on my power bar if I can turn the drivers on and off with the 1-10v.

Im using all dimmable Inventronics drivers, (5 of the 70DS, and 1 of the 105DS) so I'm not sure if there is something I can look for in the driver information or if it's something I should be able to do regardless of driver.

I got all my stuff yesterday, thanks again for that Gareth !!!! :beer:

 

[AQD_ottawa]

Yes you need the EVG card it has a zero volt switching circuit

 

[badazztealcobra]

Thanks for the fast response as usual Michael !!!

I'm looking at the EVG cards now, I'm guessing my best bet is to tin the ends of the wires and then pushing them into the terminals ??? Should I be using a precision screwdriver to press anything in while sliding the wire ends into the terminals?

Thanks again !!!!

 

[AQD_ottawa]

nope just push it home and screw it down