Hi Fellow Reefers...
I am desperately hoping that someone can resolve the problem I am experiencing with my AWC on a Profilux III eX unit I have set up as follows:
I am running 5.0.9 Firmware just recently installed
I have two Optical Level Sensors installed on a splitter in the Level 1/2 Port.
I have three pumps connected, one for Salt Water Drain, one for Fresh Salt Water Input, and one for RO/DI Water Input on ATO.
If I test each pump using Activate Manual Override, everything works fine.
I have set the AWC to Timer 8 to remove 21 litres of old Salt Water from my Sump every alternative day. My DT is 1000 litres, and my Drain Pump removes exactly 21 litres in 5 x minutes.
When Timer 8 kicks in to activate the AWC, it starts the process, but then gives me a Reset Error 20 seconds into the process, and the just comes to a grinding halt.
ERROR:
I also notice that my ATO on the RO/DI does not work at all.
I have set up the Programmable Logic tables as follows:
PROGRAMMABLE LOGIC 1:
PROGRAMMABLE LOGIC 2:
SOCKET 3: - Pump Fresh Salt Water In
SOCKET 5: - Drain Salt Water from Sump
SOCKET 6: - ATO from RO/DI Tank
TIMER 8:
SOCKETS:
ATO:
SETTINGS:
If anyone could find my fault in this process, I would really appreciate it.
Warmest regards
ATHOL
I am desperately hoping that someone can resolve the problem I am experiencing with my AWC on a Profilux III eX unit I have set up as follows:
I am running 5.0.9 Firmware just recently installed
I have two Optical Level Sensors installed on a splitter in the Level 1/2 Port.
I have three pumps connected, one for Salt Water Drain, one for Fresh Salt Water Input, and one for RO/DI Water Input on ATO.
If I test each pump using Activate Manual Override, everything works fine.
I have set the AWC to Timer 8 to remove 21 litres of old Salt Water from my Sump every alternative day. My DT is 1000 litres, and my Drain Pump removes exactly 21 litres in 5 x minutes.
When Timer 8 kicks in to activate the AWC, it starts the process, but then gives me a Reset Error 20 seconds into the process, and the just comes to a grinding halt.
ERROR:
I also notice that my ATO on the RO/DI does not work at all.
I have set up the Programmable Logic tables as follows:
PROGRAMMABLE LOGIC 1:
PROGRAMMABLE LOGIC 2:
SOCKET 3: - Pump Fresh Salt Water In
SOCKET 5: - Drain Salt Water from Sump
SOCKET 6: - ATO from RO/DI Tank
TIMER 8:
SOCKETS:
ATO:
SETTINGS:
If anyone could find my fault in this process, I would really appreciate it.
Warmest regards
ATHOL
