RGB led driver help

[Isayso]

Hi everyone
I need some information from you guys

I'm about to buy some RGB , 10 watt chip

These are the chip info

Model: 10W

Color: RGB
DC*Forward Voltage (VF): *Red 6-8V, Greed 9-12V, Blue 9-12V
DC Forward current (IF): 300MA
Out put Lumens: Red 120-150LM, Green 200-300LM, Blue 70-100LM
Wave Length : Red 620-625nm , Green 515-520nm, Blue 455-460nm
Beam Angel: 140 degrees

So I have to drive t single channel
I will follow the instructions. Mentioned above
But I want to drive It with a single
Driver.....
I I use a30-32 volts 330ma one?
Thanks in advance

 

[theatrus]

Yes, wire all three in series with a driver capable of delivering at 32V (better 34-36V to add headroom).

However, an RGB chip will be terrible for reef lighting.

 

[Isayso]

Hi theatrus, thanks for your help
Series would be +-+-+- correct?
That is making little bridges on the same chip, the "+" to the "-". Of the other side of the chip
Thanks again

 

[theatrus]

Correct!

 

[Isayso]

thanks