I have an in wall stand that got wet when my 215 split seam. The stand is still solid and level, but some of the 3/4" plywood is getting a bit wavy when it dried. It is wavy only in the center area where it does not come in contact with the tank frame. I sanded it down, but want to seal the whole thing in epoxy like bean animal did. I have looked at a number different epoxies and wondered if anyone has experience with the following:
1. UltraClear Bar and Table Top Epoxy from best bar top epoxy dot com. $80 for 16 sqft at 1/8" max thickness per coat 1/8", 1:1 resin to harder ratio, 1 gallon
2. MAS LOW VISCOSITY EPOXY RESIN, 600 cps viscosity, 2:1 resin to harder ratio, 1.5 gallon $209 or .75 gallon $121
3. U.S. Composites Kote Table Top Epoxy $40 for 16 sqft at 1/8" max thickness per coat 1/8", 1:1 resin to harder ratio, 1 gallon
I am looking for which one is the thinnest and least likely to pull up on the edges if I line it with wax paper. The stand has about .25" extra space on each side so I am concerned about a possible lip.
I am leaning towards #2 but I cannot find any info on coverage and am not sure if it is worth the extra cost.
Any feedback or other suggestions are appreciated.
1. UltraClear Bar and Table Top Epoxy from best bar top epoxy dot com. $80 for 16 sqft at 1/8" max thickness per coat 1/8", 1:1 resin to harder ratio, 1 gallon
2. MAS LOW VISCOSITY EPOXY RESIN, 600 cps viscosity, 2:1 resin to harder ratio, 1.5 gallon $209 or .75 gallon $121
3. U.S. Composites Kote Table Top Epoxy $40 for 16 sqft at 1/8" max thickness per coat 1/8", 1:1 resin to harder ratio, 1 gallon
I am looking for which one is the thinnest and least likely to pull up on the edges if I line it with wax paper. The stand has about .25" extra space on each side so I am concerned about a possible lip.
I am leaning towards #2 but I cannot find any info on coverage and am not sure if it is worth the extra cost.
Any feedback or other suggestions are appreciated.