Still Having Some Issues - Would Love Some Help

layer3switchguy

layer3switchguy

New member
Folks,

I'm still having some issues trying to figure out how to do the following:

Shut my return, skimmer and ATO off for 20 minutes while feeding. I have played around with the programmable logic, and seem to be able to shut off my return pump when pressing esc (I'm guessing this activates feed mode) but the other two devices don't shut off. Oddly enough, in PLC, it does show those sockets as off, but on the Pbar itself, the sockets shown on, and the pumps dont sut off.

Here is how I programmed it:

G1 - Delayed On - Input 1 Filter

I then set the socket the pump is plugged into (in this case socket 11) to Programmable Logic 1. I did the same for the other two devices. Again, PLC shows those sockets as "off" but indeed they are not shutting off.

Any ideas? I'm sure I've got something setup wrong. Would love some help!

Cheers,
L3
 
Thanks, tried that. No replies thus far. The down side to Profilux is that the user community doesn't seem to be as vast as Digital Aquatics. Getting help with this system on a forum is much harder than the RKL or RKE.

I've tried playing around with many different combinations of programmable logic, no luck... To make matters worse, only some sockets on my PAB even work now. Very frustrated. I miss my RKL!!
 
Thanks, I did also post this issue on Aquariumcomputer.com, which I believe is GHL's support site. Unfortunately, no response in two days there either. :(

I do appreciate you responding, and certainly think AQD has been great from a support perspective.
 
You must log in or register to reply here.

Similar threads

L
filter roller install help
Replies
3
Views
142
Vinny Kreyling
Vinny Kreyling
M
ATO Problem in JBJ NanoCube 24g
Replies
0
Views
119
MNtadpole
M
M
Frogspawn Issue Help.
Replies
10
Views
320
MNtadpole
M
Dogs442
NEED HELP WITH RO/DI SYSTEM
2
Replies
34
Views
887
griss
griss
Fish lover
My reefer 170
Replies
4
Views
371
Misled
Misled
Back
Top