I have been running my 6110 with Singlecontroler for about one month. Last night after the food timer went off the alarm sounded for the first time sense I have owned this unit. I cleaned out the suction housing (not much cleaning needed, only around 5% was blocked and checked for any other blockage. I pluged the unit back in after 15 minutes and it ran all night.
Today I turned up the speed to about 50% and the alarm went off again. I decided to clean the entire unit but this did not help as the unit will not restart as the alarm continues to sound.
Also, when I put the unit back together I noticed that the red O ring seal was loose in the drive shaft housing (by loose I mean it was towards the top of the drive shaft housing). I looked at the directions but do not see where this O ring is supposed to fit exactly.
Thanks for your help,
Steve
Today I turned up the speed to about 50% and the alarm went off again. I decided to clean the entire unit but this did not help as the unit will not restart as the alarm continues to sound.
Also, when I put the unit back together I noticed that the red O ring seal was loose in the drive shaft housing (by loose I mean it was towards the top of the drive shaft housing). I looked at the directions but do not see where this O ring is supposed to fit exactly.
Thanks for your help,
Steve