Pickupman66
New member
OK so I did some modifying of the sump last night since It is not being used due to the pump and heat issue I have experienced. I wanted to create an area that can help eliminate the micro bubbles put out by the skimmer and the tank itself. I did all of this with a sawzall since the jigsaw is missing since the move. I had it all done when we finally found it. either way, I got pretty good with that sawzall.
water enters from the tank into the small 10 gallon. it is roughly the same height as the area where it sits. the skimmer will most likely reside in that basis for the time being. once I build my work bench, it will reside on top of the bench for easier access. but for now, this will work. im putting a 1 1/2" bulkhead in that bin and was planning on plumbing it down into the far corner of the first sumparea. the water will travel around the 10g then thru the bubbletrap and then around the basin to the drain.
water enters from the tank into the small 10 gallon. it is roughly the same height as the area where it sits. the skimmer will most likely reside in that basis for the time being. once I build my work bench, it will reside on top of the bench for easier access. but for now, this will work. im putting a 1 1/2" bulkhead in that bin and was planning on plumbing it down into the far corner of the first sumparea. the water will travel around the 10g then thru the bubbletrap and then around the basin to the drain.


