Tank Stand Design 120gal

[Gridiron58]

Hi All,

I am planning my design for my 120 gal (2'x2'x4') reef tank. I plan on doing a walnut stand build with two-tone stain.

I was wondering if this frame design would be sufficient to support a tank and hood. My main concern would be using no center vertical supports on the front and rear.

From my research, I was able to gather that would be okay, so long as I used 2x6's for the horizontal frame on the top.

My main reason for doing this is I would like to leave the front open for a removable panel on the front of the stand.

Thank you all!
R/

 

[davocean]

That looks fine

 

[Kmack0415]

Using 2x6 you should be able to span a 3.5 foot gap with 0 problems. Your design looks to be pretty standard. My 90 is exactly the same, only 18 deep and I didn't use a center support and had no issues. I'm pretty sure I could stack another tank on it and still be fine lol.

 

[Kmack0415]

Apparently I forgot to add this...

 

[Ramracer32]

looks great should not have any problems

 

[billdogg]

IMHO, it will be fine even using 2x4's for the top frame. I assume you will be skinning it with something? That will add considerable strength to the stand as well.

 

[mcgyvr]

Could easily just be done with 3/4" plywood too and no "studs"..if you want to optimize space..

 

[Gridiron58]

Thanks for the responses and suggestions.

Definitely giving me something to think about.

My plan is to build it with walnut with a two-tone stain on the outside. I'm working with a local carpenter to work out the details.

R/

 

[Indymann99]

Could easily just be done with 3/4" plywood too and no "studs"..if you want to optimize space..

+1 just build a plywood box. Plenty strong if joints are square and bonded.