Tunze 6105 problem

[lpkenneys]

My new 6105 stopped working prop moves by hand, but power supply only reads 5.26V dc?

 

[Jar*Head]

You mean the transformer only up to 5.26v?

 

[lpkenneys]

yes, the output voltage of the transfomer is only 5.26 volts dc. the input side voltage is 121.5v ac. So I know I am getting good input voltage. ?

 

[rvitko]

Check that the jumper is installed correctly and try using the optional 15V jumper that came with the power supply. The jumper is a small clear tab that sits over the red LED on the power supply. It is possible to insert this at an angle where it doesn't make contact and it also acts as a sort of fuse and can burn out in a surge or overload. Otherwise it is possible the power supply is dying, make sure it did not get wet.

 

[lpkenneys]

Thanks Roger, you hit the the nail on the head, I was screwing around with the different jumpers to se the difference and must of not got it seated in right....Thanks for your responce,,,by the way... This pump....ROCKS!

 

[rvitko]

Thanks