Tunze 7095 question

[TOM BLEVINS]

Hi Roger,

first I want to say Thank You for the replacement 6305!

My question, the night mode if the mood light is not working does
this mean the night mode will not work too?

Also, I am trying to run 4-6205's & 2-6305's on my 300, I purchased
the 2 adapters to allow me to do so and I am trying to run 4 off the
channel 2 so they do not turn off all the way, but they don't seem to
do so? any help would be great.

setting's

Interval 2
1-60

Thanks
Tom









Thanks
Tom

 

[rvitko]

Tom, what model controller are you using?

 

[rvitko]

Duh, it was in the title of your post.

OK, in general if the moonlight doesn't work, water has breached the photocell and the photocell won't work. These can be replaced, on units since Nov 2008 the photocell/LED has an internal plug, older than that and 4 small wires had to be soldered to install the new one after unsoldering the old one. It is a $34 part.

If you set to pulse or Interval 2, the pumps should not turn off provided you have 2 speeds set for that channel. Interval 1 would turn them off as would Sequential.

 

[TOM BLEVINS]

Tom, what model controller are you using?

Hi Roger,

just the 7095

 

[rvitko]

Yes, I caught that after I replied, see my second reply.

 

[TOM BLEVINS]

OK,
Good I will order the part, does this effect the night mood to turn the pumps down at night?

 

[rvitko]

In general we do just sell the part installed, but besides shipping there is no other cost. If you want to open the controller (just the 4 screws on the back) and see if you have the plug type and are comfortable with the repair, I can certainly sell you one, it is an internal use part only so it doesn't have a part number you can order online.

Night mode is whatever you have the bottom know on each channel set to, so if you want a low night speed set that to the 30% speed or whatever the lowest speed you want is.