Tunze Multicontroller

[mousefish]

I'm using the Tunze 7094 multicontroller for two 6100's. Because the manual is written somewhat obtusely, what are the proper setting for running the two 6100's in an alternating fashion with one running for about 3 hours then switching to the other for 3 hours in a continously alternating pattern? I think it is the high tide/low tide setting, but am not sure.

 

[curtis hi-tech]

I have a 7095 ( not sure if there is a difference) but on it the setting would be interval 1 Then on the second dial you can turn it for the number of hoyrs that you want each pump to run for.

 

[rvitko]

On the 7094 it would be tide mode. To set it up the way you want you would plug in one pump in sockets 1, 3 and 4. The Interval LED should be on at this point. You will use the switch and knob to set the number of min/hours between switching the pumps that are on.