Tunze osmolator 3155

Kimos

New member
Hallo!

I write from Danmark, I have a problem with my new (brand new) osmolator, in that moment i turn it on, it starts to fill water, but it will not stop when the water hit the sensor, it keep filling water until the hit the safety-sensor.
On the controlebox there is no lamps there are glowing green.

Have some of you have the same problems or can you help, and say what i can do.

Kind regards
Kim Søresen
 

rvitko

RC Sponsor
RC Sponsor
I think that most likely it is just the sensor is new and new plastic repels water so it cannot sense the water. The solution is to rinse it with hot soapy water and then rinse it well and wipe it dry with a soft cloth. Also, make sure there are not a lot of air bubbles in the area of the sensor.
 
Top