Wavebox and Overflows

[nugzo]

I'm ordering a 210g AGA tomorrow and a wavebox. Should i get the corner overflows or the two rear off center overflows? What does the wavebox work best with? Also what powerheads should i get to go with the wavebox? Thanks

 

[rvitko]

The off center overflows would be best. I would get a TS24 kit to go with it.

 

[nugzo]

Awesome thanks for quick response. TS24's it is. A couple more questions if you don't mind. What locations would you install the wavebox and power heads? Where on the tank? Would the wavebox go in the corner or would u bring it out past the overflows? Thanks again.

 

[rvitko]

The wavebox must be installed on an end pane and be placed so it has an unobstructed shot at the far wall. I would place a Stream in each back corner and aim them to hit the front pane about 2/3rds of the way down.

 

[nugzo]

Thank You

 

[nugzo]

<a href=showthread.php?s=&postid=11957637#post11957637 target=_blank>Originally posted</a> by nugzo
TS24's it is. A couple more questions if you don't mind. What locations would you install the wavebox and power heads? Where on the tank? Would the wavebox go in the corner or would u bring it out past the overflows? Thanks again.

<a href=showthread.php?s=&postid=11958572#post11958572 target=_blank>Originally posted</a> by rvitko
The wavebox must be installed on an end pane and be placed so it has an unobstructed shot at the far wall. I would place a Stream in each back corner and aim them to hit the front pane about 2/3rds of the way down.

Ok i now have the wave box and the TS24 kit. Can i use the 7095 multi controller to control the wave box? If so how do i hook it up? the instructions that came with the controller and the wave box mention each other but do not give any connection examples. I have a 210g with the rear off center overflows. My setup will be mixed reef with many fish. How would you configure this setup? Simple, sequential or chance? TIA for your help!

 

[rvitko]

You have to use the wavebox controller but this can be attached to a multicontroller. The only reason to do this is if you want to alternate between running the streams and running the wavebox, it adds no other functions.