Where to put magnetic switches?

[unbreakable]

I wanted to add mangetic switches so when my doors open lights come.. I know it's something super basic.. Where would I attach this on a profilux III. They look like this:

http://www.made-in-china.com/showro...L/China-Magnetic-Contact-Switch-BS-2011-.html

I'll be getting my PIII in a couple of days


thank you

 

[unbreakable]

one more thing, are there any water leak detection sensors for the profilux?

 

[AQD_ottawa]

Hi

You will need PLM-ADIN card so you cna have multiple DIY inputs such as the sensor you mention. This has analogue and digital inputs.

There are no wet floor sensors however the most reliable type of leakage detection sensor would be in sump, therefore no matter where the leak takes place it will be detected by a sudden drop in water level. I have a float switch in my sump for this exact purpose it is set slightly lower than the water top off sensor so it does not trip everytime evaporation takes place.

It trips when about 2 pints have been lost and shuts off the main pumps and filters.

The sensor is set to leakage 1 in the level sensor input screen

 

[unbreakable]

Hi

You will need PLM-ADIN card so you cna have multiple DIY inputs such as the sensor you mention. This has analogue and digital inputs.

There are no wet floor sensors however the most reliable type of leakage detection sensor would be in sump, therefore no matter where the leak takes place it will be detected by a sudden drop in water level. I have a float switch in my sump for this exact purpose it is set slightly lower than the water top off sensor so it does not trip everytime evaporation takes place.

It trips when about 2 pints have been lost and shuts off the main pumps and filters.

The sensor is set to leakage 1 in the level sensor input screen

Thank you! Do I need anything else after purchasing PLM-ADIN in order for it to get working right away with my switches?

 

[AQD_ottawa]

Providing it works with a break circuit style action which I think it does this will just wire directly into the PLM-ADIN card.

 

[boboxx]

yes those are just reed switch, the adin card is all you need

 

[unbreakable]

thanks for the clarification, went ahead and ordered!