workhorse 6 wiring

[poolkeeper1]

Anyone that can draw a wiring diagram for a two bulb setup for dummies?
In other words where the red go and where the yellow go? I know the black and white are for the plug but the rest I'm not sure.
Don't want to blow up any bulbs If I can help It, Thanks In advance
This Is for T5 HO bulbs BTW
Bill:dance:

 

[andywe]

Are you wanting to run them in series (off 1 plug) or control them independanlty (by adding a switch in between)?

Assuming single (reccomended), attache the red wire to one end cap and the yellow wire to the other endcap of each. Done.

Here is the link to the wiring chart. http://www.lightingsupply.com/company/pdf/fulhamlampchart.pdf

On page 5, look at diagram 11.

 

[waynesworld]

Bill picture one the lower picture you will have extra wires though I know it looks more complicated then it is. you only use three of the wires two red that go on one side of each then one yellow that will tie to both bulbs on the other side.

BTW if you are in the area and want a few bulbs to test with let me know I have some laying around.

 

[poolkeeper1]

Thanks much everybody, I have some old bulbs laying around to test It out. It's better safe than sorry.
Bill