6000 not working

[achenator]

I have a couple-weeks-old pair of 6000's and a 7095. I looked at my 7095 earlier and all the lights were off and only the channel lights at the bottom were blinking dimly and strangely. I unplugged the pumps and one went to full blast and, the second one was dead. I took off the cover and checked for intruders and nothing. I removed the propeller and magnet assembly, everything looks fine. I dont dose any thing, there is absoultely no buildup. Nothing has gotten wet, other than the pump and I tried switching around the electronics and still nothing from that pump. Any ideas?

 

[jmaneyapanda]

how is your power supply? Could that be marginal?

 

[rvitko]

Try running the controller with just the pump that went full blast. If everything checks out the other pump is probably bad and we can get it replaced.

 

[achenator]

I left the good pump plugged in to the controller overnight and it seems to still be working fine. Still nothing from the other one.

 

[achenator]

ygpm.. address???

 

[rvitko]

Tunze USA
1304 Monica St
Austin TX 78758


Thanks!

 

[achenator]

I sent this out on Sat. , you should be getting it soon.

 

[rvitko]

It' s here. Showed up yesterday at closing, I should have it out to you by days end.

 

[achenator]

Got it back today, thanks for the quick service. What happened? Do i have to worry about it happening again??

 

[rvitko]

The driver was bad, it could happen again but it is not very likely, once in a while one of them just has a defect.