6100 problems?

[2x210g]

Need help........ my Tunze 2x6100 w 7095 controller only goes to 80% when set for interv. 2. it would go from 80% back to 30%on each pump buti would like it to go 100% to 30%. its plug in input 1 and 3 right now.

 

[rvitko]

Is the set up new or a few months old or more?

 

[2x210g]

it's 3 days old

 

[rvitko]

Your multicontroller is probably defective. The pump is going to 100% but their was a batch that the resistor that controlled the illumination of the top LED was too strong. It was right at the limit where sometimes it lights up on certain pumps but if the combined resistance of cables, and the driver are just a bit too high the LED doesn't light up. Please PM me your address and I will get you a pick up and I will swap out the circuit board with a new one. The pumps will run fine without the controller in the meantime.

 

[2x210g]

did you get my address cause i send it out about over a week ago. thanks roger.

 

[rvitko]

I still do not have it. Can you track it?