Mappelbaum37
New member
I have taken all the steps needed to get rid of algae. I just realized that I'm getting red slime again. I now have hair algae, cyano, and diatoms. I changed the tank in early January and started getting red slime in late january. Since then I have been getting diatoms and hair algae. I am down to a few conclusions. If I remember correctly red slime or cyano bacteria meant there are excess nutrients in the water.
*The tank change was removing crushed coral substrate for 40 lbs of non live sand and 20 lbs of live sand. Also added 20 lbs of rock. Now have 100 lbs.
1) I am using RO water now. I need to get a TDS meter and test for TDS'. I am planning on getting an RO/DI unit.
2) chaeto/macro algae. I had chaeto in the in-tank fuge and it didnt really do anything. It was a small amount, but I think I might just get a new batch when available and try and let that help out with nutrients.
I'm thinking I'm still cycling bec. last week I tested ammonia and it was .25 It has been .25 since january. If the tank is still cycling, this is one hell of a long cycle.
Am I missing anything?
phosban reactor running for approx. 2 months
switched from carbon to chemi-pure in fluval 405
clean fluval more frequently (only runs chemi-pure and sponges
switched from spring to RO water about 3 months ago.
switched from 5 to 10 gallon water changes.
upgraded from prism skimmer to octo bh 300f
increased flow
added to clean up crew
shortened light cycle ( 6 hrs of daylight)
Was thinking of getting an extra filter sock for fluval to help detritus.
Thanks
*The tank change was removing crushed coral substrate for 40 lbs of non live sand and 20 lbs of live sand. Also added 20 lbs of rock. Now have 100 lbs.
1) I am using RO water now. I need to get a TDS meter and test for TDS'. I am planning on getting an RO/DI unit.
2) chaeto/macro algae. I had chaeto in the in-tank fuge and it didnt really do anything. It was a small amount, but I think I might just get a new batch when available and try and let that help out with nutrients.
I'm thinking I'm still cycling bec. last week I tested ammonia and it was .25 It has been .25 since january. If the tank is still cycling, this is one hell of a long cycle.
Am I missing anything?
phosban reactor running for approx. 2 months
switched from carbon to chemi-pure in fluval 405
clean fluval more frequently (only runs chemi-pure and sponges
switched from spring to RO water about 3 months ago.
switched from 5 to 10 gallon water changes.
upgraded from prism skimmer to octo bh 300f
increased flow
added to clean up crew
shortened light cycle ( 6 hrs of daylight)
Was thinking of getting an extra filter sock for fluval to help detritus.
Thanks