ca reactor media

[fishguy597]

I have a rx1 reactor set at 1 bubble per sec. Its set on at 6.7& off at 6.5. The problem is that the water in the reactor keeps getting milky. I turn it off for a while and it clears out I turn it back on a while later and it turns to milk again. Is my meadia going bad? its not turning to mud .
BTW I calibrated the ph probe for my apex same result.

 

[fishguy597]

Bump

 

[sirreal63]

What media are you using?

 

[fishguy597]

Carrab sea the fine stuff.

 

[sirreal63]

The PH is too low for fine media.

 

[Conlius]

it's melting! Increase pH and check effluent.