Lukel
New member
Hello, I currently have a mtc procal reactor. Controlled by apex. And a khg monitor, with apex module.
Currently when khg gets a sample over 8.3 kh It turns off the co2 solonoid. Which is ok... but
Is there a way to have 2 sets of ph ranges.
For example: if my kh is over 8.3 then run the reactor ph between 6.8 and 6.75
And if kh is below 8.3 then run reactor from 6.6 to 6.65?
Thanks in advance.
Currently when khg gets a sample over 8.3 kh It turns off the co2 solonoid. Which is ok... but
Is there a way to have 2 sets of ph ranges.
For example: if my kh is over 8.3 then run the reactor ph between 6.8 and 6.75
And if kh is below 8.3 then run reactor from 6.6 to 6.65?
Thanks in advance.
