I had major leaking issues from my MAG7 but I think i've got them all figured out.
I can't get my closed loop pump to prime. I have a priming cap but when I pull it off water rushes out. Do i need to make the cap taller?
I've tried using a MJ pump to push water into it. I've tried blowing water through a tube to try to prime it. I've turned the pump on and off but I can't get it to run.
I've got a single 1" drain reduced to 3/4" with a 1/2" return going into 4 3/4" outlets. Is my plumbing too big or small?
Here is a picture of my setup. This is the first plumbing job I've done and I have changed it 4 or 5 times from paper to reality.
I can't get my closed loop pump to prime. I have a priming cap but when I pull it off water rushes out. Do i need to make the cap taller?
I've tried using a MJ pump to push water into it. I've tried blowing water through a tube to try to prime it. I've turned the pump on and off but I can't get it to run.
I've got a single 1" drain reduced to 3/4" with a 1/2" return going into 4 3/4" outlets. Is my plumbing too big or small?
Here is a picture of my setup. This is the first plumbing job I've done and I have changed it 4 or 5 times from paper to reality.