reefrookie2013
New member
I am new to reef keeping this year, making lots of rookie mistakes along the way. Today I did the following:
I have a 6 canister RODI system with
1 micron sediment filter
5 micron carbon block
0.6 micron carbon block
RO membrane
DI resin
DI resin
Unfortunately I hooked up the tap water to the output area today :-( Was tired and not being careful. It must have run for 1 minute or two when I finally realized what I did. Then, I hooked it up the correct way, and turned on the TDS, which measured 160 in and 003 out while it was being primed the correct way, then when I flipped the valve on (inline), it measured 023 and then after about 30 minutes it measured 003. None of this went to the reservoir.
So, do you think I am safe to use the output of this RODI system or will I have to replace everything in the system before I make RODI water safely again?
I have a 6 canister RODI system with
1 micron sediment filter
5 micron carbon block
0.6 micron carbon block
RO membrane
DI resin
DI resin
Unfortunately I hooked up the tap water to the output area today :-( Was tired and not being careful. It must have run for 1 minute or two when I finally realized what I did. Then, I hooked it up the correct way, and turned on the TDS, which measured 160 in and 003 out while it was being primed the correct way, then when I flipped the valve on (inline), it measured 023 and then after about 30 minutes it measured 003. None of this went to the reservoir.
So, do you think I am safe to use the output of this RODI system or will I have to replace everything in the system before I make RODI water safely again?