DYI calcium reactor

L

larrybird

In Memoriam
Well since I am going to be breaking down my 220 to redo some plumbing. (had a major flood the morning of St. James gathering), I figure I will once again use a calcium reactor. I decided to try my hand at making one. I am using a 14" piece of 8"x 1/4" wall cast tubing for the main body. Flanges were cut from 1/4 " sheet and were cut by Fordguy1992 I am going to use a Eheim 1048 for the recirculating pump but if need I will use a Pan world 10PX. I should have it assembled by early next week, ( need to get a few more plumbing pieces). Here are a few pictures of the unassembled parts:
100_3622.jpg

100_3625.jpg

100_3624.jpg

100_3626.jpg

100_3627.jpg

I will contimue as the build goes along. ....
 
Hopefully i will have it online by the end of next week. Still need to pick up a few fittings and the refulator.
 
The screen is make from plastic gutter guard. I have a brand new piece that I am going to be using instead of the old one inside the skimmer.
 
Looking really good. How much do you have invested in it so far. I really like the bubble counter. Congrats on an awesome DIY project.

Jeremy
 
well I have around $120.invested that includes the $65. for the Pan world pump. I was lucky enough to have the 8" acrylic which i bought on ebay a few years ago. (cost me $40.) If I had to buy the acrylic tube id say it would cost around $140. total
 
You must log in or register to reply here.

Similar threads

J
Calcium very elevated
Replies
3
Views
960
jcarlilesiu
J
Reefing102
Equipment needed for a full calcium reactor set up?
Replies
4
Views
718
five.five-six
five.five-six
O
Confused on Algae Reactor
Replies
7
Views
981
oceanfrank
O
adova
300g DIY Acrylic Tank Recommendations
Replies
5
Views
447
griss
griss
five.five-six
Calcium reactor pH problem
Replies
3
Views
551
ct_vol
ct_vol
Back
Top