cardiffgiant
Active member
I am selling my Gen-x PCX40 pump. I bought it used for use as a backup and I would like to sell it to buy the same pump that I use as my main.
I've owned it for 3 years, but I only put it into service for 2-3 months a year. This little thing is a runner. I use it to move water from my basement sump to my 1st floor display with a headloss of roughly 14 feet. It's a little louder than my blueline pump, but it isn't bad. It's also an unbelievably low 90watts to run.
Local pickup for $90. Be ready to take a frag or two home as well
Features:
"¢Non-corrosive polypropylene housing
"¢Non-leak sealless pump
"¢Highly efficient, economical type
"¢Single phase motor with thermal protector
"¢Allowable ambient temperature: 0 to 40C
"¢Pumps are gravity feed design
"¢Not allowed to run dry
"¢Max Flow: 1190gph
"¢Max Head: 22ft / 6.8m
"¢Speed: 3000rpm
"¢Fittings (Inlet/Outlet): 3/4in MPT / 3/4in MPT
"¢Comparable to Iwaki 55RLT
"¢Economical to run-1.2amps,110Volts, 90 watts
"¢Quiet,cool running,no oiling required.
"¢PSI rating 10
I've owned it for 3 years, but I only put it into service for 2-3 months a year. This little thing is a runner. I use it to move water from my basement sump to my 1st floor display with a headloss of roughly 14 feet. It's a little louder than my blueline pump, but it isn't bad. It's also an unbelievably low 90watts to run.
Local pickup for $90. Be ready to take a frag or two home as well
Features:
"¢Non-corrosive polypropylene housing
"¢Non-leak sealless pump
"¢Highly efficient, economical type
"¢Single phase motor with thermal protector
"¢Allowable ambient temperature: 0 to 40C
"¢Pumps are gravity feed design
"¢Not allowed to run dry
"¢Max Flow: 1190gph
"¢Max Head: 22ft / 6.8m
"¢Speed: 3000rpm
"¢Fittings (Inlet/Outlet): 3/4in MPT / 3/4in MPT
"¢Comparable to Iwaki 55RLT
"¢Economical to run-1.2amps,110Volts, 90 watts
"¢Quiet,cool running,no oiling required.
"¢PSI rating 10
