GHL Mitras Club

At this point, not entirely sure. But a mix of SPS, LPS, an assortment of fish, and maybe a ray.

But for now, I'm wanting to simply setup the tank with just enough fish (or amomium) to cycle it and get things growing. Then add corals, but only after coraline, etc has started to grow.

I know I wan to use the Mitras lamps but uncertain if 1 will be enough for what I need to do right now. From what Ive heard, I will end up needing 3 based on physical size of tank (72x27,24)
 
balloonpilot does your tank have a single cross brace or 2? For some people it doesn't matter but with 2 cross braces you'll have some shadowing with just 2 units. It's possible you won't see it due to the amazing spread of the Mitras but it is something to take into consideration.

Worse case you could start with (2) units and add a 3rd later if you see it's needed.

Al
 
bonjour, j'ai installé 2 mitras 6200 le 07/07/2014 .

mon bac fait 130/100/60

j'ai tué mon aquarium à cause des mitras.

j'ai mis trop de lumiere et quand j'ai vu que les pointes des coraux devenez blanc et sans polypes, j'ai pas vu que c'etait à cause des mitras .

quand j'ai vu, c'etait trop tard, j'ai perdu tout mes sps .

actuellement le bac est vide, je vais le refaire, donc attention à ne pas bruler vos coraux.

hello, I installed 2 mitras 6200 the 07/07/2014.

my tank is 130/100/60

I killed my aquarium because of mitras.

I put too much light and when I saw that the tips of corals become white and without polyps, I have not seen that it was because of mitras.

when I saw it was too late, I lost all my sps.

currently it is empty, I'll do it again, so be careful not to burn your corals.
 
bonjour, j'ai installé 2 mitras 6200 le 07/07/2014 .

mon bac fait 130/100/60

j'ai tué mon aquarium à cause des mitras.

j'ai mis trop de lumiere et quand j'ai vu que les pointes des coraux devenez blanc et sans polypes, j'ai pas vu que c'etait à cause des mitras .

quand j'ai vu, c'etait trop tard, j'ai perdu tout mes sps .

actuellement le bac est vide, je vais le refaire, donc attention à ne pas bruler vos coraux.

hello, I installed 2 mitras 6200 the 07/07/2014.

my tank is 130/100/60

I killed my aquarium because of mitras.

I put too much light and when I saw that the tips of corals become white and without polyps, I have not seen that it was because of mitras.

when I saw it was too late, I lost all my sps.

currently it is empty, I'll do it again, so be careful not to burn your corals.

What does your project look like? Can you upload it for us to see? Also were you running at 100% high efficancy or high output?
 
Can anyone help with the moon simulation? Like I don't no what to set it at and for how long what percent times ETC

Can you please get into as much detail about it as you can please.

Many thanks
 
Hello Mitras owners looking to find out if anyone can give me the set points for all nine channels with percentages to replicate this bulb? possibility the best bulb ever crated.
Michel
picture.php
[/IMG]
 
They are not pale at all it's just the crappy I phone and the light being very white. Vs some of the shots being taken under attinic lighting rather than full day light
 
Back
Top