Magfloat question

[Randrew215]

I have a razor attached to the front of my mag float. Despite my best efforts, it rusts and I clean it and replace the blade. I've always detached it from the tank and kept it stored when not in use. If I just leave it attached with the blade submerged, will it still rust? Is this what people generally do, or do they store them when not in use? Thanks.
-Andy

PS. Finished setting up my tunze ato today. I am very pleased.

 

[reefman5511]

As long as there's oxygen in the water it will rust. The rate may be slower but it will happen.

 

[tent boy]

I have the same set up. I take the blade out each time and wipe it off. I bought the extra stainless blades and they will rust too. Works great but is a pain to take out each time.

 

[Steve Canyon]

I use single edge razor blades. They will rust within minutes if not rinsed and dried. I find that if I use rodi, they stay perfectly clean til I use them the next time.

 

[Randrew215]

Thanks for the feedback. I have replacement blades, but I've been rinsing in tap without removing the blade. Maybe this will lengthen the blade life and reduce the effort.

 

[Gary Majchrzak]

I remove the blade and rinse in tap after every use.

I've been using the same rust-free blade for several years now.

 

[Grenade Glass]

are these special mag floats which have an attachment for a razor, or did you all DIY attach the blade? if thats the case, how did you go about it?

 

[Johnny C]

After owning the razor attachment, I'll never go without one again... makes short work of coraline!

Like Gary, I always remove the magnet after use and rinse with tap. Grenade, here's a pic. It glues to the wet side of a large Magfloat.

 

[Grenade Glass]

thanks johnny!, ive been using a single edge razor blade, but i have a hood, which makes the task a pain in the rear. im gonna have to order one up!