Magnets
- Thread starter dmorrow
- Start date
No, about 2 months ago we started to include them. Germany is extremely environmentally conscience so it took a lot of convincing to get parts included that may be thrown away and that is why they were not included before. They are in there now though. Their is a seperate bag that will have instructions for Oceanic and some long stainless steel screws with a black anodized coating. Follow the oceanic instruction but cut the black plastic ferrule to be a spacer since AGA trim is thicker and a bigger spacer is needed. Place one end in the suction cup and screw the threaded end to the bottom of the rail.
Joboo
Member
rvitko said:
Ferrule?? Is that a long black cylinder looker thing that is threaded inside?(I only know because I have an osmolator). If that is what's needed than my stream did not come with that. It looks to have all other parts included(Stainless steel mounting screws). By the way, all mounting hardware came in the same bag. I did not get a separate bag.
Thanks
John
The black cylinder is it. It acts as a spacer, you should have gotten a few parts a tiny screw, a nut, a suction cup and that ferrule- all can be used as spacers depending on the situation. I guess they changed it again. I will check one of mine in inventory tomorrow.
Joboo
Member
Roger,
I was able to get the bracket to work. These things are awesome!! The flow is great. Not too strong yet it moves alot of water. I'm glad I went with 2 6000's. I figure I can always dial down alittle if needed. So far I have them on full force with no problems. I'm still looking forward to getting the magnets as I'm alittle concerned about how sturdy those brackets are. Have you had any problems with the brackets coming off? Thx
I was able to get the bracket to work. These things are awesome!! The flow is great. Not too strong yet it moves alot of water. I'm glad I went with 2 6000's. I figure I can always dial down alittle if needed. So far I have them on full force with no problems. I'm still looking forward to getting the magnets as I'm alittle concerned about how sturdy those brackets are. Have you had any problems with the brackets coming off? Thx
Joboo
Member
rvitko said:
I think I may have confused you. It does work. The bracket is tight and does not move. I just was worried about how secure it will be. There doesn't seem to be any room for error since there is little material actually holding the bracket onto the tank(outside part of the tank).
You could possibly shim the magnet upwards slightly with a small piece of plastic at the bottom. They come with rubber feet that improve adhesion and try just applying them at the bottom to see if that does it. Otherwise I don't know of any way to slightly up angle them.
Similar threads
