I ordered 2 6055's from Marine Depot and was a little confused when one of the boxes was missing the "Elastic pads for Magnet Holder" These small adhesive "dots" go on either side of the magnets. The one I have in service I love but I am trying to see if Marine Depot will get me the pads so I can put the other one in my tank. If Marine Depot is unable to help, is there any way I can get these from Tunze? As they weigh less than 1 oz I can't see them being all that difficult to send out. Thanks for any assistance.
Missing pads on 6055
- Thread starter wolf pup
- Start date
Ok, and looking through the forum, I notice that the clips marine depot set with the 6055's are the old ones...I did not break the one I put together but is this going to be a problem in the future? I have not assembled the 2nd in case marine depot wants the whole unit back.
Jon
Jon
The clamps you have are the new ones, Marine Depot should definitely not have 6055's with old clamps as they were sold out before the pumps with new clamps arrived in late September. You can only tell the clamp by a small tear drop on the back of the tabs, it is a very subtle detail, the main difference is a different plastic. I can mail you a set of the rubber feet. Just PM me your address.
