MP40 Stopped Most Functions

[Typlus5]

I have an Gen 1 MP40 that has been working fine until it recently attempted a firmware update through Reeflink. It will not take an update nor connect with the Reeflink. I cannot change modes or the original program is gone.
I can manually dial up the fan but it's stuck in the constant mode. The blue line indicator quit working as well.
I've tried the factory hard reset until I've been blue, red, white flashing in the face. The "W" is lit but not sending signal. Any help or is it toast?

 

[Typlus5]

I drew the line on the dial so I could tell the output level.

 

[EcoTech Support]

I have an Gen 1 MP40 that has been working fine until it recently attempted a firmware update through Reeflink. It will not take an update nor connect with the Reeflink. I cannot change modes or the original program is gone.
I can manually dial up the fan but it's stuck in the constant mode. The blue line indicator quit working as well.
I've tried the factory hard reset until I've been blue, red, white flashing in the face. The "W" is lit but not sending signal. Any help or is it toast?

Your unit is not bricked, just stuck in a failed upgrade. Please try the legacy VorTech upgrade again through EcoSmart Live. Depending on the amount of RF you have in your house, it might take a few times. Try increasing or decreasing the amount of distance between your ReefLink and the VorTech driver until you find a sweet spot. It will eventually work. It typically works on the first try, however the process is long running and prone to interference. It is recommended that you turn off your Radions and other VorTechs during the update.

 

[Typlus5]

Thanks for the advice. The Radions were the culprits, Vortech now updated and working properly.

Technology will be the end of civilization as we know it!

Thanks Shaun.