Multicontroller and Voltage Question

[lark]

I know this was answered here a couple of weeks ago, but I can't find it.

If using the 6055 with the 7095, does it make any difference what voltage the 6055's transformer is set to?

In other words, if the 6055 is set to be pulsing from 30 to 100 percent on the 7095, for example, is that 30 to 100 percent of the total (24v) capacity of the 6055, or is it 30 to 100 percent of the flow for the voltage as set on the transformer?

 

[shawnz28]

Yes the voltage on the transformer should be set to 24v if you want the pump to run at full speed on the controller at 100% So yes your last point is the correct one

 

[rvitko]

You can set both, so if you have it set to 24V your flow is being adjusted from 30-100% of the max 1450gph, lowering the voltage lowers the maximum and minimum.

 

[lark]

Cool. That's what I was hoping the answer would be.

I don't suppose you'd have the stats available and could say ballpark what the max and min would be for 18v and 20v?

 

[rvitko]

I don't but I would say the ballpark would be a top end of 1100 and 900 respectively.

 

[lark]

As always, thanks Roger. (Looking at those numbers, seems I probably should have figured that one out myself.)