Nano Stream 6025 shroud keeps popping off...

[flipteg]

i have 2 Nano Streams 6025 that i got as replacements from Roger back in July 2007... although the pumps have been great, the way i have one of the pumps angled in the holder causes the top part to pop off... it doesn't do it all the time, but every time i finish cleaning the pumps, it seems like i always have to go through this ritual of repeatedly positioning the pump to the holder and tugging on the cord cause it keeps getting in the way... i was wondering if it has been fixed in other revisions or is there a new shroud for it that stays in place...?

 

[rvitko]

Usually this happens if the cover is squeezed into an oval, if you just squeeze it back into a round shape it should lock in properly.

 

[flipteg]

what i noticed is, the top part of the shroud doesn't hold as well as the previous ones i had... it's like it doesn't even clip in...

also, the cable is putting a significant strain against the shroud... the part of the shroud where it contacts the cable is actually wearing down... the cable is digging into the plastic...

 

[rvitko]

PM me an address and I will send a new one to try.

 

[ktar]

dont mean to invade the thread but i having the same problem and my tunze has a hard time starting back up when i shut it off for cleaning. it also rattle when it runs.

 

[rvitko]

Probably the shaft is broken, send it in to us for replacement:

Tunze USA
305 Victor St
Austin, TX 78753