Need Reeflo/Baldor motor diagrams

[el aguila]

I have recently tore apart an older hammerhead and a barracuda to replace noisy bearings/seals. I would like to get ahold of the motor diagrams for both of these pumps, but am not having much luck.

I have one thrust/spring washer that I believe came out of the Barracuda. Which I have committed a major sin of tearing any motor apart - PAY ATTENTION TO HOW THINGS COME APART!!!!

Anyway, my experience says that frequently such washers are on both sides of the bearings to maintain the shaft in the center also reducing noise. I would just like to see a diagram to be sure that I'm reassembling it in the proper way. Ex. Maybe there were originally two and one got worn away, etc.

I have tried on this Baldor site, but didn't find anything:
http://www.baldor.com/support/product_manuals.asp

I have also asked Reeflo, but yet to receive a reply.

Here is a pic of the hammerhead motor plate

The Barracuda motor plate

 

[el aguila]

Anyone?

 

[uncleof6]

Reeflo are the ones you need to speak with. These motors are special motors made for Reeflo. The numbers, save for 56j, do not match any current Baldor motors. Reeflo has a pump rejuvination program for old/not running pumps. Send it to them, and you get a "like new" warranty when you get it back. The information IS on their website. I had the link, but due to a power outage, I no longer have it. If you can't find it, I can find it again later. Reeflo is likely the only source of info on these particular pumps.

 

[el aguila]

Thanks! I did get a reply back from reeflo. Unfortunately they really don't have what I need either.

Since these are special motors, I guess that is why I can't find anything on the baldor site.

I went ahead and assembled the hammerhead last night. Before installing the volute, the motor tested fine without load. I'll be putting it back on the system today.