new 6105 pumps

[befer]

ordered new pumps on boxing day and just got around to setting up tank one must be old style 6105 and 1 new but both had same impeller shaft setup so do i just remove impeller from shaft and place in new half shaft .
also would i use end rubber pieces on the half shaft pics would be good as tunze instructions online are terible

 

[rvitko]

You cannot convert a full shaft pump to a half shaft pump. I am unclear on what you are asking as the new pumps should have come assembled and ready to go so nothing should have to be changed or added. If you got replacement motors you will just move over part 3005.740 and the magnet with prop, the end rubber bushings and shaft are not used with the new motor with built in half shaft.

 

[befer]

new 6105 pumps

sorry about post but when i took first pump out of the box it was in one piece when i took 2nd pump out it was in separate pieces. i must have gotten wrong parts in second because when i compared the two the impeller part i got for the pump with the half shaft was the same as the one with without half shaft so what i was asking was are the impeller parts themselves the same for the shaftless motor and the half shaft motor and if they are i can just remove impeller part from shaft and insert on half shalf without the end bushings
i hope this is understandable only ever 3rd post online

 

[rvitko]

The drive units for both pumps are the same, but you will leave out the shaft and blue end bushings and only install the 3005.740 disk and magnet and prop on the half shaft model.

 

[befer]

thank you