Lol
I've never tried that.
New bane of my existence in reefing
- Thread starter reefing102
- Start date
I've never tried that.
Well then, in typical Lounge fashion we need to make it a poop thread
BeanAnimal
Premium Member
You def should bypass or remove the membrane when new carbon blocks are added
The carbon filters are full of fine dust that can clog the membrane. It is not the end of the world if you don't, but I would def remove the flow restrictor and run 10-15 mins of water in "fast flush" mode to clear the membrane the best I could.
I've run them for nearly 10 yrs before. If the TDS on the membrane output hasn't risen, no need to replace.
Agreed.
I'm going to install one.
Lol no worries! There’s actually a good amount of helpful info. First time having an RO system and first time changing them. I have a John guest bypass on my system so that’s good to know. I’ll just connect the waste line to it
That's probably for flushing the ro membrane.
It’s right after the carbon block. I have a separate bypass or at least I can make it a by pass for the RO membrane
Most units have a bypass valve before the membrane to bypass the flow restrictor to flush the membrane.
