Pinouts for the Tunze NanoStream 6055

[Harry_Fish]

I'm loking for the pinouts for the NanoStream 6055's

I looked all over the web last night and was unable to find them.

Does any one have them or can direct me to them.

Thank you

 

[Jar*Head]

Harry, what is the pinouts?

 

[shawnz28]

if you are looking for a diagram of what wire in the MIDI cable does what, i THINK this was asked before and if I recall correctly Roger said he did not have the wiring diagram

 

[Harry_Fish]

Hmmmm,

Tech support????

 

[wartskin]

Please be patient with us. Roger is in Germany and may not have access to the internet at all times. Once he has a chance to log on and go through the treads he will get all of the questions that myself, shawnz28 or any of the other guys cannot answer.

 

[rvitko]

I am sorry but we don't provide that information.

 

[Harry_Fish]

I found the info I needed, since I'm using it with a Profilux
Controller I only need ground and the control voltage lines.

Pin 1 :Control Voltage (3-8vdc I believe)
Pin 2 : - VGD (Ground)
Pin 3 :
Pin 4 :
Pin 5 : + VDC

I orginally was going to use a New Hydro Korola controllable
pump with a simple 556 dual timer and a FET I could control it
and it would cost about a third the price.

So why didn't I you may ask...

I was looking for the easier way out, and since a Y-cable
is easier to build up than a small pc board the Tunze won.
(Plus the Tunze Nano's look nicer)

Had I not found the needed info I would have just gone with the Korola's