doxyman
Premium Member
Roger,
My brother-in-law recently purchased an Osomat that I was helping to set up. The problem we are having is trying to maintain a constant level within the osomat box.
We hooked everything up, plugged it in and the level in the box begins to drop. The reservoir pump turns on and runs for about ten seconds then turns off but the level continues to slowly rise. It gets high enough to make the float "bounce", causing the alarm to go on and off repeatedly. So we turn everything off, remove a small amount of water (about a cup), double checked everything and tried it again. This time the little pump drains the box, blows a ton of bubbles, kicks the pump back on and the whole process starts over again.
So is there anything we can check or may have overlooked? Any help would be appreciated.
Thanks
My brother-in-law recently purchased an Osomat that I was helping to set up. The problem we are having is trying to maintain a constant level within the osomat box.
We hooked everything up, plugged it in and the level in the box begins to drop. The reservoir pump turns on and runs for about ten seconds then turns off but the level continues to slowly rise. It gets high enough to make the float "bounce", causing the alarm to go on and off repeatedly. So we turn everything off, remove a small amount of water (about a cup), double checked everything and tried it again. This time the little pump drains the box, blows a ton of bubbles, kicks the pump back on and the whole process starts over again.
So is there anything we can check or may have overlooked? Any help would be appreciated.
Thanks