scengineer
New member
I trimmed off the outer needle weedle and attached 3 layers of the enkmat mesh. When I turned the skimmer back on the water level in the skimmer was about 1" lower. There wasn't a noticable changed in the size of the bubbles or consistency of the foam.
Basically, it looks exactly like it did before the mod.
Any suggestions on how to improve? More mesh?
I didn't trim the nubs from the inner needle wheel because I though it would help hold the mesh and affirm it better to the wheel.
Basically, it looks exactly like it did before the mod.
Any suggestions on how to improve? More mesh?
I didn't trim the nubs from the inner needle wheel because I though it would help hold the mesh and affirm it better to the wheel.