Problems updating modules after installing 4.04_2b11

[Nexenn]

I connected my laptop directly and successfully installed the new firmware and web pages. Then I disconnected the laptop and reconnected the apex to the network and logged on wirelessly. I connect fine, the web pages are updated but I went to my module setup page and it shows:

HW Type HW Rev SW Rev Addr Name
Display module 001 007(OLD) 001 Disp_1
Display module 001 007(OLD) 002 Disp_2
EB8 module 001 006(OLD) 003 EB8_3
EB8 module 001 007(OK) 004 EB8_4
Display module 001 007(OLD) 005 Disp_5
Display module 001 007(OLD) 006 Disp_6
Display module 001 007(OLD) 007 Disp_7
Display module 001 007(OLD) 008 Disp_8

I try to update them and it loads a pop up window that just refreshes itself over and over and nothing actually updates.

Do I need to hook my laptop back up? Any ideas of whats going on?

 

[Nexenn]

Oh and no graphs will load at all. And I have data under the data log...

 

[Nexenn]

.... I'm not sure why there is 6 diplay modules but my lunar sim isnt showing up either???

 

[Nexenn]

anyone?

 

[Deleted member 143833]

.... I'm not sure why there is 6 diplay modules but my lunar sim isnt showing up either???

LunarSim will not show up because it is NOT a module; only AqauBus devices are considered modules; X10 devices like the LunarSim are legacy devices.

The extra displays, don't hurt anything and you can delete them (or not); if you delete the 'real' one it will be added back.

 

[Deleted member 143833]

Oh and no graphs will load at all. And I have data under the data log...

Have you tried to flush your browser cache?

Just to be sure; updating the web pages is a separate step...

 

[Nexenn]

Yes I ran the firmware update sucessfully, THEN ran the web pages update.

Now I cant get my outlet programming to accept my pH2 probe, and it is enabled and ORP is disabled