Profilux with DIY LED's

[triggers_150]

Hello,

I have a some DIY LED's that I have made that are controlled with a dimming option on the MW driver that is 0-10V.

My questions is does the Profilux controller work with this application and what options would I need.

I would also like to run my Tunze with this as well so this is just a cable option?

Thanks

 

[AQD_ottawa]

Hi

Yes the GHL leads the field in control of DIY LED's

all you need is the EVG-AP control card and thats it these are about $39.00 for a two channel card.

 

[triggers_150]

I was looking for some advice on which unit I could start with.

I am just trying to understand what will work best for my needs.

I am still doing reserch on these as well.

 

[AQD_ottawa]

this all depends on what else you want from the controller other than LED control. If it is just LED then look no further than the ProfiLux Light II bar, however this is restricted to only 4 channels so you could only have 4 drivers working independantly, of course you can have more than one driver off of one channel but they will react together, all depends on how much independant control you want.

Next up would be the ProfiLux Plus II, lots of expansion full blown aquatic controller and upgradeable to the much respected and demanded profiLux 3

or go head over heals straight into the P3

it all comes down to what you want now, and keep in mind for the future in terms of control features both in lamp and other features.