Puck questions

[nadking]

I have some amateur questions for you guys that I just can't seem to find the answer too. I am new to tunze pumps and I recently picked up 2 tunze 6100.10 pumps from a couple of fellow reefers. Unfortunately, one has the 7210.202 transformer and the other has the 7410.602. I would like to switch out the 7210 for the 7410. On the website I have found both of the transformers but if I were to order one would it come with a standard US plug? Last question is where can I find the connector to go from the driver to the 7094 multi-controller.

Thanks in advance

 

[Bryan]

You should be able to get the connector from Radio shack, it is a standard 5 pin DIN cable.

 

[nadking]

I just picked one up from radio shack. I was a little surprised it worked because the prongs were a little skinnier than the one I have, works great tho.
Thanks,
Still looking for the puck!

 

[dahenley]

The pucks are no longer made. (i think he said they havent been made sine 2009???)
you can find used ones, and sometimes "roger" gets some good used ones every now and then, but not likely.
the 7210 driver makes your 6100 a 6000 pump.
nothing wrong with it, but just a little less flow.

You can trade in your pump for an upgraded 6105? it would cost 199 or something like that (but only after they recieve your trade in pump)

or, you can run th 6000 till it breaks or you get a different power supply. and after that point, you can trade up.

Roger might chime in and help you out some more.

 

[nadking]

thanks, I think I am just going to scavange the used puck market to try and find one.

 

[rvitko]

Essentially, you have a 6000 and a 6100, the only difference was the voltage of the transformer. You can upgrade or downgrade by just changing the transformer, but the US model is no longer available, looking for used is your best option.