SMS module support

[MSHUR]

hm.. wouldnt let me left click on sms screen

 

[MSHUR]

 

[MSHUR]

I cant chnage internal clock with computer time either..

 

[AQD_ottawa]

Dont press load after changing the time just save.

I need your sms set up screen, where you type in the message etc

 

[MSHUR]

 

[MSHUR]

time wouldnt change, after 2-3 min goes back to 11.59pm

 

[AQD_ottawa]

delete all references to Profilux 2 and then re set up just for profiLux 1 and send message and see what happens

I think as I said before this is a network query due to the two ProfiLux's linked together so it is confused what one to send the data of.

 

[MSHUR]

but, Profilux1 and 2 set up at different time , i dont think its the case. maybe this has to do with the time ( internal clock) that is not corresponding with computer time.?
I will wait till matthias wake up

 

[Matthias Gross]

I woke up

Questions:
a) What are the addresses of both ProfiLux?
b) Is "Router" for both ProfiLux enabled?

Clock: works usually, I will check if there is a condition where it doesn't update

 

[MSHUR]

Good morning

Answears:
a. profilux1-address (1)
profilux2-address (2)
b. "router" enable for both

 

[Matthias Gross]

newest firmware in both ProfiLux?

increase max. response time -> 2s

 

[MSHUR]

yes, both updated to a newest firmware

ok, i will increase to 2s.

any info on clock, i still have 11.59pm

 

[AQD_ottawa]

I had the same issue with the Clock until matthias told me to stop pressing load after save was fine after that

 

[MSHUR]

i didnt press load ,just safe and after 2-3 min coming back to 11.59pm

 

[Matthias Gross]

Mike,

tomorrow I will built here a similar system like you have, with RS485 conection, 2x View and so on.
Then I can tell you what to do.

 

[MSHUR]

Sound good... :thumbsup:

 

[Matthias Gross]

Mike, I have now exact the same system like you have

It works when you increase the response time (10s). It was possible to send SMS with sensor information of ProfiLux 1 and 2.

The problem is that you have a very "extreme" system regarding communication:
- Both ProfiLux communicate with each other
- View 1 speaks with ProfiLux 1, View 2 with ProfiLux 2
- PC communicates to both over LAN and RS485
- and on top of this: SMS-modul talks to both ProfiLux at once
-> too much communication traffic causes delays in responses

I hope it works for you with longer response times, you will get better results when the PC is not connected during the SMS module tries to send a SMS.
For the future I try to increase the communication speed with the next firmware.

Displayed time in ProfiLuxControl: I had not time to check this today, maybe tomorrow. But don't worry, the internal time in the SMS-module is correct.

 

[MSHUR]

Hi Matthias,
thank you. I am at work right now, soon as i get home i will try this settings..hope it works..
So, you saying internal clock has nothing to do with my problem?

question:Sms will send sensor info for both profilux or i ahve to set up different time ? ( thats what i have now)


mike

 

[Matthias Gross]

only for the one ProfiLux with the address you have entered in the SMS-settings

-> you have to send 2 different messages

 

[MSHUR]

ok... thats exactly how i have now...