tunze help

[Creetin]

How do i keep a constant ebb and flow between 2 tunze's I am at my wits end trying to figure it out. It gets close but then it drifts off.
They are running off profile 1=2.

 

[schwaggs]

How do i keep a constant ebb and flow between 2 tunze's I am at my wits end trying to figure it out. It gets close but then it drifts off.
They are running off profile 1=2.

Post up your profiles and program for your pumps. Also, how big is your tank and which Tunze pumps are you using?

 

[Creetin]

I have a 300 gal marineland DD. It is 6 ft by 3 ft and 27 inches tall.I am using tunze 6201's

I just want a simple resonance like a wavebox and keep it in sync
Thanks!!!
This is where i am at now, I have tried numerous times and dif configurations to no avail.
Heres the profile for pf1..
Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 10
On time (Seconds) 10
Off time (Seconds) 5
Minimum intensity 0
Maximum intensity 70

Heres PF2

Synchronize Enabled
Divide by 10 Enabled
Initial off time (Seconds) 0
On time (Seconds) 10
Off time (Seconds) 10
Minimum intensity 0
Maximum intensity 70

 

[aquamanic]

Don't enable sync on both profiles, only PF2. It will sync to the next lowest profile, PF1.
Disable 'divide by 10' on both profiles - as is you're times are tenths of a second and you need more than that.
For PF1, try times of 10, 10, 0
For PF2, try times of 0, 10, 10

These are taken from Curt's testing on various tanks and are documented in the old Neptune V4 user manual. See if they help at all.

 

[Creetin]

Thank you. They are alternating now. Just have to find a sweet spot.

 

[aquamanic]

Good deal