zanemoseley
New member
I'm still semi-new to fragging yuma's but I thought I'd put up a little guide on how to frag a yuma and attach the frags to your plugs.
First you need a fresh razor blade, make sure there is no oil on the blade. Next, gently cut off the yuma from the rock its on. Its best to kinda slowly work around it and then cut toward the middle.
Now you should have a single yuma to be fragged. Place it on a clean surface to cut. I put it on my kitchen counter but I'm in an apartment and don't worry about the counters but if you're in a house avoid damaging your counter.
Now its time to cut the yuma in half. Use a side to side cutting motion, don't simply just press down. Try your best to get half the mouth in each of the halves.
Now its time to cut one of the halves to pieces. Try your best to get a piece of the mouth with each of the new frags. Cut this like you would a pie from the center outward.
Repeat this step for the other half. The number of frags you cut will be determined by how large the original yuma is and how large you want each of the frags.
I have been using pieces of ceramic tile as frag plugs. I took a piece of cheap tupperware and drilled many 1/8" holes in it for flow. Place each frag on its own frag plug. In my case the tupperware is placed on an eggcrate rack only about 2" underwater so the top of the tupperware was out of the water, this eliminated the chance of the frag floating out into the open water. If there is a risk of the frags floating off you can rubberband a piece of seran wrap around the mouth of the tupperware and cut slits in it to allow for some flow. It is also best to put the tupperware in an area of low to medium flow.
Now you're done, the yumas should begin attaching in about a week and begin forming into a circle again. The mouth will regenerate in time.
First you need a fresh razor blade, make sure there is no oil on the blade. Next, gently cut off the yuma from the rock its on. Its best to kinda slowly work around it and then cut toward the middle.
Now you should have a single yuma to be fragged. Place it on a clean surface to cut. I put it on my kitchen counter but I'm in an apartment and don't worry about the counters but if you're in a house avoid damaging your counter.

Now its time to cut the yuma in half. Use a side to side cutting motion, don't simply just press down. Try your best to get half the mouth in each of the halves.

Now its time to cut one of the halves to pieces. Try your best to get a piece of the mouth with each of the new frags. Cut this like you would a pie from the center outward.

Repeat this step for the other half. The number of frags you cut will be determined by how large the original yuma is and how large you want each of the frags.

I have been using pieces of ceramic tile as frag plugs. I took a piece of cheap tupperware and drilled many 1/8" holes in it for flow. Place each frag on its own frag plug. In my case the tupperware is placed on an eggcrate rack only about 2" underwater so the top of the tupperware was out of the water, this eliminated the chance of the frag floating out into the open water. If there is a risk of the frags floating off you can rubberband a piece of seran wrap around the mouth of the tupperware and cut slits in it to allow for some flow. It is also best to put the tupperware in an area of low to medium flow.


Now you're done, the yumas should begin attaching in about a week and begin forming into a circle again. The mouth will regenerate in time.