kwl1763
Premium Member
Roger, I have 4 6100s on a 7094 multicontroller. While cleaning one of the 6100s today I noticed that the prop would not stick all the way back in. Upon further invistigation here is what I think is the issue and tell me what you think.
Looking at the drive unit
The little piece on the far right, I assume is the piece that sticks down at the bottom of the "barrel". The side we can't see has the groove where the prop rests. Is this correct?
One of mine seems to have flipped. I can see the part we see in the picture sticking up toward the prop. The would make it not seat properly. Does this sound right? If so can I fix it? Ok after reading a bit it looks like a 5mm screw should let me get it out. Is this correct even flipped?
Nevermind!!! Done with a screw. Flipped it and all is well!!!
Looking at the drive unit
The little piece on the far right, I assume is the piece that sticks down at the bottom of the "barrel". The side we can't see has the groove where the prop rests. Is this correct?
One of mine seems to have flipped. I can see the part we see in the picture sticking up toward the prop. The would make it not seat properly. Does this sound right? If so can I fix it? Ok after reading a bit it looks like a 5mm screw should let me get it out. Is this correct even flipped?
Nevermind!!! Done with a screw. Flipped it and all is well!!!
Last edited:
