9002 nano skimmer keep overflowing

[rvitko]

We would be repairing the skimmer you have, my assumption is that it is only a simple issue with how it is assembled or installed, it is a very simple unit and I have any parts needed on hand. I plan to check that everything is technically correct, replace anything if needed, test it, take photos showing it working properly and send it back pre tuned and ready to go. I will have the skimmer repaired and on the way back to you within 2 days of getting it.

 

[Mirugai]

Re: 9002 nano skimmer keep overflowing

Ok. I'll send it in as soon as I get back. Thank you.

 

[Mirugai]

Hi vitko,

as I was preparing the skimmer for shipping, I found out what the problem is (i think). The propeller cover case for the pump is missing, so nothing locks the propeller cover from staying in the pump case, this is the most outter plastic cover that locks the propeller guide in place, therefore I think that this causes the inconsistent draw from the pump.

Do you have the replacement part for this?

 

[rvitko]

Please PM me your address and confirm that you need part 1073.084, we will send one out.

 

[Mirugai]

under page# 22 in the manual, it's part no 1073.008. In the picture of page 22, It's the one on the bottom right next to the circled number 8. I PM you now.

 

[Mirugai]

I don't see part 1073.084 anywhere in the manual. Can you tell me where I can see the illustration for the parts mentioned?

 

[rvitko]

1073.008 is the entire pump, but the part next to 8 is 1073.084, the break down of pump parts is further to the back of the manual.

 

[Mirugai]

That's it!! 1073.084 Housing Locking Bar. Thank you! PM sent.

 

[Mirugai]

Re: 9002 nano skimmer keep overflowing

I got the part, the skimmer is running like a champ. Thank you!

 

[rvitko]

Good to know and thanks for your persistence.