RIGUY314
Member
I was finally able to set up my Genesis Renew system today. I am reading right now how to do the programming, however on manual mode, it works great.
Attached are couple of pictures of where I installed the system. I attached the 1 Gallon Reservoir (metering) buckets to the frame surrounding my Quarantine Tanks. I have the buckets approximately 6' off the ground.
[/IMG]![]()
[/IMG]![]()
In a nutshell, the bucket on the left side will fill up with freshly made SW out of one my 200 gallon storage/mixing tanks. If too much water goes into the bucket, it will overflow back into the storage tank. The bucket on the right side fills up with water from my sump. Same process as with the other bucket. Too much water from the sump will overflow back into the sump. Flow into the reservoir/metering buckets are being handled by two small Eheim pumps.
When both buckets are full and any excess or overflow drained, the freshly made SW will dispense into my 90 gallon rock tank which drains into my sump. The bucket filled with the sump water will drain outside.
I have plugged the control panel into one of my EB8's on my Apex. Power to that circuit will shut off if my Floor/Flood Sensors are tripped or if my sump is running low.
My initial plan is to program the unit to perform 10 gallon water changes every 24 hours or 70 gallons per week. I will still be doing my regular weekly maintenance and will gravel vac and manually drain more each week. As I get comfortable with this system, I may increase my automatic water changes.
it looks like a cool system. if you could post updates on Genesis it would be great. I was reading on their products on their site. Did you by any chance bundle it with their Storm ATS?