AI Hydra Settings Thread

I have mine set at 20%chance 60%coverage


QUOTE=ReefTankHunter;22508271]Is anyone using the cloud sweep.If so what are your settings.Thanks.[/QUOTE]
 
If u were close I would send u 3

thanks for the information

UOTE=Sonicboom;22508315]I haven't tried a new cable as they are the mini USB and don't have any extra of those, now if they would have used micro USB cables I would have about 50 of those.

My max whites are at 35%[/QUOTE]
 
Just got two hydras for my 75 today. Director and the hanging bracket is on backorder until Friday. Can't stand the wait. LoL.

I do have a question, Can you control the lights with just the director or does it require the remote as well?
 
Sooooo got a new light and same issue. Much be my controller. Especially since now it's not turning on at all. Lights are now stuck on. What can I do??
 
Since it's getting dark, take em off tank and start from scratch. I can connect to help make sure nothing was missed if you want.
 
So it's been a few weeks and I've been adjusting trying to clear up the brown sand bed which came when I installed the 52s. No3 and Phos or extremely low (no change to what it was before). I've been. Following this thread and posted early on. After seeing what others have, I am going to drop R&G down and lower my whites. Here is what I just set mine to:

W-30% for 7 hours with 1.5 ramp up/dn on each side
R-11am-9pm ramping up to 8% at 4pm and back down
G- same as Red
RB- 70% from 11am-6:30pm with 2 hour ramp on each side
DB - Same as RB
V- 40% from 11am-6pm with 2 hour ramp on both sides
UV-20% from 1-7pm with 2 hour ramp on each side.

I will monitor the sand bed and corals. Corals appear good now, but perhaps they'll get even better growth.
 
No just searched em. 2 hydras found and set up. Again deep blues didn't work then the controller took dump and won't turn on at all now
 
Laptop might be pushing out less than 5v and it might need more than that if the wireless adapter is plugged in
 
AI Hydra Settings Thread

My LFS is getting the director on tomorrow. Gonna just grab that then. Why not ya know?! Upgrade Lol
 
Wow that is weird, this might be redundant - did you push the little red button till the light turned green on all the lights?
Also I think if you push it too long it goes into demo mode.
I hope u have better luck with the director, just fyi insure the director and lights are on the same floor

Never had a problem before. It's the controller for sure. No power in any way plug or anything
 
I had to use a different USB cable as mine wouldn't stay powered up. I had one for a camera I had and used it and it powered it up. Did you try a different USB cable?
 
Back
Top