bosworth
Premium Member
I have an ASM G1X with the Gate Valve Modification and has had the Mesh Needle Wheel Modification done. The skimmer is about 14 months old. The pump is the stock Sedra 3500. The unit has been cleaned and is ready to drop in for use.
After running it I have decided that it is just too large for my system. I have moved down to an RC80.
I have also tapped the collection cup in two places so that you can drain it into a seperate container included. The second hole was an overflow in case the large collection container overfilled. I had to do this because I would travel for long periods of time and I wasn't always home to check on it.
I'm asking $150.00. I'll post it here for a week if I dont see any interest it's going up on the Used Equipment Forum.
Thanks,
Brian
Specifications:
Skimmer is rated for tanks up to 150 gallons.
Pump is submersible or inline.
Powerful, quiet, reliable
Has a ceramic shaft
Uses 20 watts, 115 volt, 60 hz
Max head height: 7'
Max flow rate: 250 gph
Inlet: 0.75", outlet: 0.5"
Size:
Skimmer is 5.5" diameter x 22.5" high, with a 8.5" x 10" footprint.
After running it I have decided that it is just too large for my system. I have moved down to an RC80.
I have also tapped the collection cup in two places so that you can drain it into a seperate container included. The second hole was an overflow in case the large collection container overfilled. I had to do this because I would travel for long periods of time and I wasn't always home to check on it.
I'm asking $150.00. I'll post it here for a week if I dont see any interest it's going up on the Used Equipment Forum.
Thanks,
Brian
Specifications:
Skimmer is rated for tanks up to 150 gallons.
Pump is submersible or inline.
Powerful, quiet, reliable
Has a ceramic shaft
Uses 20 watts, 115 volt, 60 hz
Max head height: 7'
Max flow rate: 250 gph
Inlet: 0.75", outlet: 0.5"
Size:
Skimmer is 5.5" diameter x 22.5" high, with a 8.5" x 10" footprint.
