Hi Bertoni,
thank you very much for your article on DSB.
I have a question regarding the grain ratio of the aragonite sand that you listed in your post.:
A depth of 6" (15cm) is usually the deepest that is suggested, with 4" (10cm) a likely minimum for reasonable effectiveness. The sand must be chosen carefully for particle size. Most or all commercial sand mixes are too coarse, so some careful research is suggested. This sample distribution (given in millimeters) is a good starting point:
When you get the different grades of sand, do you then mix them together at the appropriate ratio, or you have to layer them in a particular order?
Thanks,
Yiorgo
thank you very much for your article on DSB.
I have a question regarding the grain ratio of the aragonite sand that you listed in your post.:
A depth of 6" (15cm) is usually the deepest that is suggested, with 4" (10cm) a likely minimum for reasonable effectiveness. The sand must be chosen carefully for particle size. Most or all commercial sand mixes are too coarse, so some careful research is suggested. This sample distribution (given in millimeters) is a good starting point:
When you get the different grades of sand, do you then mix them together at the appropriate ratio, or you have to layer them in a particular order?
Thanks,
Yiorgo